|
|
Product rating |
|
Voting |
|
|
|
|
|
|
Author: Unknown
Runs pretty well with a kda 24turn inrunner, used on a hbcp2 tail. Possible to mount 20mm motors such as mine by sanding 4 parts in the inside.
|
Author: Unknown
Well made, and quite good balanced.
Light weight. Performance is what promised, and much more if you secure fan to motor axle with CA-glue.
Good value for money.Only minus, no intake ring.
|
Author: Unknown
I used it on my mini AMX. I removed the 5 blade and used this one. It needed some cutting up to the lip to fit the stock motor and to drill the fan whole with a 2mm drill. other than that it fitted VERY WELL..
I used it on 4S with stock motor and ESC. THE PLANE was a BLAST :) ballistic speeds and very safe with 4S packs.. hit more than 100mph downwind very dureble plastic with no flexing and no rubbing o nthe shroud I'm very happy with it
|
Author: Unknown
Used this to replace stock fan unit for the 50mm EDF planes (F-16, F-18, F-36, etc...). The fan housing's "lip" is in the rear like the stock fan so no foam cutting necessary. Stock motor (4300kv) will work with this fan. Will need to drill slightly larger hole for fan. Will need to cut back cylinder into which motor fits in order to get front plate of motor to fit into housing. 15 minutes total of easy mods in my opinion. Will get more
|
Add your review here |
|
|
