Associated 4019 12R5.1 Factory Team Kit

This is the electric powered, radio controlled, Associated Factory Team 12R5.1 1/12 scale On-Road Pan Car Kit.

Features

• Associated 4019 12R5.1 Factory Team Kit

• Chassis: 0.10" (2.5mm) thick woven carbon fiber with top plate,wide rear pod for easy installation of brushless motors and better heat dissipation, Factory Team pivot ball-link chassis allows for independent roll, bump and alignment adjustment

• Drive: Two wheel rear

• Ball Bearings: Full set included

• Differential: Ball type

• Motor Mount: Factory Team blue machined aluminum

• Shock: Factory Team shock with through-shaft design for equalized damping throughout the full stroke with no unwanted rebound, shock also controls chassis droop and adjusts with a turnbuckle wrench, woven carbon fiber center shock tower with four mounting positions

• Suspension: Pivot ball link rear suspension allowing independent adjustments for chassis roll, bump and alignment, active strut front end with symmetric components and adjustable caster and track width

• Bumper: Foam front

• Caster: Adjustable, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis

• Camber: Adjustable, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle

• Ackerman: Adjustable with spacers, Ackerman describes the effect of the inside front wheel turning faster than the outside front wheel during turns

Specifications

• Length: 10.4" (265mm)

• Width: 6.7" (170mm)

• Wheelbase: 7.7" (196mm)

• Weight: 29.3oz (830g)

• Internal Gear Ratio: 1:1

Contents

• Associated Factory Team 12R5.1 Pan Car Kit with decals, 96T spur gear illustrated instruction manual

Requirements

• Radio: 2-channel with mini steering servo

• Electronic Speed Control: For stock or modified motor

• Motor: 540 size

• Battery: 4-cell sub-C 2x2 flat configuration

• Battery Charger: Peak type for selected battery

• Wheels and Tires: 1/12 scale on-road

• Pinion Gear: 61 pitch, number of teeth dependent on selected motor

• Body: 1/12 scale high downforce type

• Building and track equipment

Comments

• For Replacement Ball Bearings use:
  Qty.     Size            Location                     Qty      Bearing Set
  2       1/4x3x8"       Rear Axle                    2         ASCC7600
  2       1/4x3x8"       Ride Height Adjuster     2         ASCC7600
  8       1/8x5/16"      Fr & Rear Wheels         4         ASCC4125