Custom Works 0912 Intimidator SE
This is the electric powered,
radio controlled, 1/10 scale Custom Works Aggressor Super Speedway Kit.
Features
-
Custom Works 0912 Intimidator
SE
-
Chassis: 0.12" (3mm) thick
carbon fiber, adjustable front and rear width
-
Shock Towers: 0.12" (3mm)
thick carbon fiber
-
Rear Body Mount: 0.12" (3mm)
thick carbon fiber
-
Shocks: Four oil-filled,
aluminum bodied with coil over spring
-
Transmission: Stealth type,
with adjustable slipper clutch, mounts in either rear or mid-motor
configuration and is easily switchable
-
Differential: Ball type
-
Battery Mount: Plastic cradle
molded for six cells and Velcro straps to hold cells, multiple chassis
mounting positions
-
Caster: Adjustable front and
rear, caster/toe-in refers to the angle of the front suspension when viewed
from the side of the car in relation to the chassis
-
Camber: Adjustable, camber
refers to the angle of the tops of the tires from vertical when viewed from
front or behind vehicle
-
Steering: Sliding rack with
adjustable Ackermann, Ackermann describes the effect of the inside front
wheel turning faster than the outer front wheel during turns
-
Spur Gear: 48 pitch 81 tooth
composite construction
Specifications
Contents
-
Intimidator SE Racing Chassis
Kit with shocks, small tube of diff grease, spur gear, and instruction
manual
Requirements
-
Radio: 2-channel with one
standard size servo
-
AA Batteries: 8 for
transmitter
-
Motor
-
Pinion Gear: ASCC5258, 48
pitch to match spur gear, 21 tooth is good starting point for the above
motor
-
Electronic Speed Control:
Compatible with number of turns of selected motor
-
Battery: 6-cell
-
Battery Charger: Timed or peak
for 6-cell pack
-
Body: 1/10 scale lightweight
racing type CSWC9001, CSWC9017
-
Building and track equipment
Comments
|
|
