Duratrax G-27CS Racing Engine Super Start Ready DTXG0257

This is the DuraTrax/SuperTigre G-27CS Super Start Ready Racing Engine for the DuraTrax Warhead Evo and the Raze Truggy.

Features

• Duratrax G-27CS Racing Engine Super Start Ready DTXG0257

• Pre-installed back plate and nut for DuraTrax Super Start operation

• ABC cylinder construction-"A"luminum piston,"B"rass cylinder liner that is "C"hrome plated

• Dual ball bearing-supported SG (pilot) style crankshaft

• Dual needle Slide Valve Carburetor

• Machined aluminum blue cylinder head

• Rear exhaust

• Three year limited warranty

Specifications

• Displacement: .27 cu in (4.4cc)

• Bore: .72 in (18.2mm)

• Stroke: .67 in (17mm)

• Horsepower: 2.5 hp at 30,000 RPM

• Practical RPM Range: 3,000-35,000

• Weight: 14.1oz (400g)

• Distance Between Mounting Holes Same Side: .83" (21mm)

• Distance Between Mounting Holes Opposite Side: 1.4" (37mm)

• Height from Bottom of Mounting Tabs/Top of Cylinder Head: 3.6" (92mm)

• Height from Bottom of Crankcase to Top of Cylinder Head: 4.2" (107mm)

• Width at Mounting Tabs: 1.8" (46mm)

• Distance from Pull Start to Front Bearing: 3.3" (84.5mm)

• Distance from Pull Start to End of Crankshaft: 3.9" (99mm)

• Diameter of Exhaust Opening: .59" (15mm)

• Diameter of Carburetor Opening: .56" (14.2mm)

• Factory Needle Settings:

• High Speed Needle: 4.5 turns OUT from closed

• Low Speed Needle: 12.5 turns OUT from closed (1 turn IN from flush with ball link body)

Contents

• DuraTrax/SuperTigre G-27CS Super Start Ready Racing Engine with glow plug

Requirements

• DuraTrax Kwik-Pit Super Start (DTXP6001)

• Fuel: Car fuel blend with 20% nitromethane content

• Glow starter, plug wrench and track equipment

Comments

• This engine is intended for use in the DuraTrax Warhead EVO and the Raze Truggy and does not include an instruction manual. Refer to engine installation and maintenance sections in their manuals.