Duratrax Kwik-Pit Super Start DTX HPI .12-.18 DTXP6000
Put an end to recoil starter headaches and add one-hand starting ease by
installing the Kwik-Pit Super Start System from DuraTrax on your model.
This version will convert recoil or Roto Start equipped HPI .12-.18,
DuraTrax Velocity .15-.18 and DuraTrax Torq .21, Picco .12-.18 and
Dynamite .12-.18 size engines
Features
-
Duratrax Kwik-Pit Super Start DTX HPI .12-.18 DTXP6000
-
Easy one-hand starting means
the end of blisters and broken recoil ropes
-
Powerful twin 540 motors are
powered by twin 6-cell sub-C stick battery packs (not included) Unit will
not operate on only one pack
-
Steel gear drive
-
Dust and impact resistant
composite plastic case
-
Hinged access door provides
for easy battery installation
-
ON/OFF rocker switch with
safety side guards
-
Twin ball bearing-supported
gear drive
-
Two clips on the unit's bottom
for storage of starting shaft
Specifications
-
-Starting Unit
-
Length: 10" (254mm)
-
Width: 2.1" (53mm)
-
Height: 4" (101mm)
-
-Starting Shaf
-
Length: 7.25" (185mm)
-
Diameter: .21" (5.4mm)
Contents
-
One Kwik-Pit Super Start power
unit
-
One front and rear gear case -
key number 20 (DTXP6055)
-
One 32 tooth steel, adapter
gear - key number 14
-
One 11 tooth steel, small
adapter gear - key number 12 (DTXP6045)
-
Four 2.6x10mm hex head screws
- key number 25 (DTXQ0283) (requires a 2mm allen wrench for installation -
DTXR0252)
Requirements
-
The stock engine back plate
and one way bearing
-
Two 6-cell sub-C batteries and
charger - DTXP4600 or modeler's choice
-
Installation following
included instructions sheet
Comments
|
|
