Duratrax Photon Speed 2 Motor w/Connectors Evader EXT DTXC3301

This is the Photon Speed 2 Motor (20 turn, single wind) from Duratrax. This is the stock motor found on the Duratrax Evader EXT.

Features

• Duratrax Photon Speed 2 Motor w/Connectors Evader EXT DTXC3301

• Great for monster trucks

• 20 Turn

• Bushing motor

• Standard (not laydown) brushes

• Non-adjustable timing

Specifications

• Turns: 20

• Winds: 1(single_wire)

• Stock for 7.2-8.4 volt battery

• Uses oilless type brushes

• Shaft Diameter: 3mm

• Shaft Length: 12mm

• Overall Length: 68mm

• Outside Diameter: 36mm

Contents

• One motor

• Two pre-installed capacitors

• Pre installed bullet-type motor leads

Requirements

• Two 3mm mounting screws

• Bullet-type leads for speed control, if needed (TRIC5500)

Comments

• BREAK-IN

• For proper break-in, use a 3-5volt power source, run the motor with no load. The contact patch should take up at least half of each brush's surface. Do NOT use more than 5volt power, as the commutator may be damaged.

• MAINTENANCE:

• Brushes wear out! Continuing to use worn brushes will ruin the commutator and interfere with its ability to conduct electricity (the worn part of the commutator will appear dark). Overhaul your electric motor often. Inspect the brushes at the first sign of wear usually after 5 to 10 Nicd packs are run). Inspect and clean the Brush Holder frequently. The contact between the brush and the commutator becomes bad if the brush holder is filled with dust or dirt. If brushes show sign wear, replace the pair.