Features

• Brand New Dynam ESC Program Card DY-1014

• ESC program card makes setting up ESC a breeze. Plugging it into the ESC, it will give you the options to change

* Brake ON/OFF
* Cut off type HARD/SLOWDOWN
* Throttle curve LINEAR/ LOGARITH
* Motor type OUTRUNNERS/INRUNNERS

• Dimension: 28x40x3.5mm /  1.1x1.6x0.13"

• Weight: 3.9g

• English Manual included.

• Works only with Dynam ESC

Introductions

• To program a Dynam ESC effectively, align the black jumper cables with the desired settings on the program card. Once done, connect the brushless motor to the ESC, and then connect the ESC to the program card on the “ESC?side. Once this is done, simply connect the battery to the ESC and wait for a single beep to emanate from the motor, which will signal that the ESC is properly programmed.

Card Info

• Brake: Off - when "On," a zero stick value will halt the main rotor and cause damage - more commonly used for fixed wing aircraft.

• Outrunner/Normal: Please select which motor you are using either outrunner motor, or an inrunner.

• Cutoff: “Soft?is suggested for helicopters ?slowly lowers rotor r.p.m. when battery voltage drops.

• Linear: Sets up a progressive throttle curve that maxes out at full collective/throttle.

• Logarithm: Advances throttle at a faster rate, allowing more r.p.m. at lower stick values - better suited for outrunner motors.

• External 4.6V Power: Only necessary when ESC does not have an internal BEC (Battery Eliminator Circuit).