EMS EMO1020 Dual E-Switch Futaba J
This is a Dual E-Switch for Futaba
Radios by EMS
Features
-
EMS EMO1020 Dual E-Switch
Futaba J
-
Lightweight Design
-
Control Two Functions with one
Radio Channel
-
Each Output is rated for 5
continuous amps and up to 30 volts
-
Each Output can be configured
for Momentary of Latching Mode
Specifications
-
Length: 1.5"
-
Width: 1.5"
-
Height: 0.75"
-
Wire Length: 11"
Contents
-
One E-Switch Unit
-
One Length of Solder
-
One Instruction Sheet
Requirements
Comments
-
Negative of battery gets
soldered to two center hole on the board.
-
Positive wires from function
(Motor, etc.) get soldered to the holes closest to the MOSFETs.
-
Momentary mode means function
will be ON while the radio stick is away from center. When stick returns to
center function will turn OFF.
-
Latching means function will
turn ON and remain so when stick is moved from center. Function will turn
OFF when stick is moved again in the same direction.
-
Unit is basically an ON/OFF
switch that is controlled by the radio stick. It would be similar to having
extra switches on the radio itself.
-
Unit is NOT proportional.
-
If either output of the Dual
E-Switch is used to control a motor, install a diode (1N4001) between the
motor and the terminals.
|
|
