Fuji Imvac BT-24EI 24cc/1.5CI Gas Engine
This is the BT-24EI Gasoline Airplane Engine from Fuji Imvac.
Features
-
Fuji Imvac BT-24EI 24cc/1.5CI Gas Engine
-
Electronic ignition offers
full 30° timing sweep for better idle and top end performance
-
Dual ball bearings on both the
crankshaft and connecting rod
-
Easy straight-out throttle
linkage
-
Compact muffler fits into
cowlings easier
-
Walbro carburetor features
easy-to-use butterfly choke valve
-
THREE YEAR warranty
Specifications
-
Displacement: 1.46 cid (24cc)
-
Practical RPM: 1,200-11,000
RPM
-
Output: 2.2 bhp @ 10,000 RPM
-
Weight: 3.20 lbs (1,453 g)
with muffler 2.95 lbs (1,342 g) without muffler
-
Fuel ratio, gas/oil mix:
100-150:1, (1:50:1 for break-in)
-
High Speed Needle Setting:
Open ¾ turn from closed, ±¼ turn in Winter
-
Low Speed Needle Setting: Open
1/3/8 turn from closed, ±¼ turn in Winter) NOTE-It is not necessary to
change needle settings if engine runs smoothly. Normally only the "H" needle
will need adjustment from time to time and only a small amount.
-
On-Center Mounting Holes, Side
to Side: 2.7" (70mm)
-
On-Center Mounting Holes, Top
to Bottom: 3" (76mm)
-
Engine Height, Including Spark
Plug: 6.5" (165mm)
-
Length from Muffler to Carb
Opening: 5.75" (146mm)
-
Length from Mounting Plate to
Magneto Rotor: 4" (102mm)
-
Length from Crankshaft to
Magneto Rotor: 4.5" (114mm)
Contents
-
One BT-24EI Gasoline Airplane Engine from Fuji Imvac with Champion
RCJ6Y resistor spark plug, plug wrench, muffler, motor mount,
instruction manual, prop flange with washer, prop bolt, friction
ring, 4mm hex wrench and Electronic Ignition System
Requirements
Comments
|
|
