Futaba 10CA R3110DPS Synthesized Air 72MHz Md2 No Servo FUTJ9150

This is the Futaba 10 CA 10 Channel RC System with the R3110DPS Receiver. No servos included. This version is Mode 2-Left Hand Throttle and Right Hand Elevator, USA Standard This is the airplane version which will default to airplane settings, with mode 2 stick operation when powered up and has a ratcheted throttle stick.

Features

• Futaba 10CA R3110DPS Synthesized Air 72MHz Md2 No Servo FUTJ9150

• Enhanced airplane, heli and glider software

• Big 160 x 72 LCD with backlighting, adjustable contrast and auto-off 15 model memory (expandable with optional camPACs)

• Smart Switch Technology (SST) logic switches allows activation of a functon when specific switch and/or stick positions occur

• Modes 1-4 selectable, modes 3-4 programmable

• Assignable functions/switches

• Eight programmable mixes (4 linear/(4) w/5-point curves

• Nine factory defined mixes: Elevator-Flap, Ailevator (for dual elevator servos), Throttle-Needle, Aileron Differential, Flaperon, V-Tail, Elevon, Snap Roll and Air Brake w/elevator delay Dual/Triple rates (4ch)

• Exponential (4ch)

• Idle Down

• Throttle Cut

• Throttle Delay

• Throttle Hold & Idle Up with Delay

• Two independent gyro settings

• 7-point throttle curve

• Flap Trim

• "Full Functionality" trainer system (trainer cord not included)

• One year limited warranty

Specifications

• Transmitter;

• Power Supply: 9.6V NT8S700B NiCd battery

• Receiver;

• Intermediate Frequency: 10.7MHz & 455kHz

• Power Requirement: 4.8V NiCd battery

• Current Drain: 40mA

• Size: 1.27 x 2.17 x 0.80" (32.2 x 55.2 x 20.3mm)

• eight: 1.25oz (35.5g)

• Channels: 10

Contents

• 10C Transmitter

• TP-FSM RF Module

• R3110 DPS 10 channel Receiver

• NT8S700B 700mAh Transmitter Battery, FUTM1460

• FBC-19B4 TX, RX Wall Charger, FUTM1830

Requirements

• Servos depending on type of aircraft

Comments

• This radio is also available in helicopter default mode; FUTJ9151.