Futaba 10CH R3110DPS Synthesized Heli 72MHz Md2 NoServo FUTJ9151
This is the Futaba 10 CH 10 Channel RC System
with the R3110DPS Receiver.
No servos included.
This version is Mode 2-Left Hand Throttle and Right Hand Elevator, USA Standard
This is the helicopter version which will default to helicopter settings, with mode 2 stick operation when powered up and has a non-ratcheted throttle stick.
Features
-
Futaba 10CH R3110DPS Synthesized Heli 72MHz Md2 NoServo FUTJ9151
-
Enhanced airplane, heli and
glider software
-
Big 160 x 72 LCD with
backlighting, adjustable contrast and auto-off 15 model memory (expandable
with optional camPACs)
-
Smart Switch Technology (SST)
logic switches allows activation of a functon when specific switch and/or
stick positions occur
-
Modes 1-4 selectable, modes
3-4 programmable
-
Assignable functions/switches
-
Eight programmable mixes (4
linear/(4) w/5-point curves
-
Nine factory defined mixes:
Elevator-Flap, Ailevator (for dual elevator servos), Throttle-Needle,
Aileron Differential, Flaperon, V-Tail, Elevon, Snap Roll and Air Brake
w/elevator delay Dual/Triple rates (4ch)
-
Exponential (4ch)
-
Idle Down
-
Throttle Cut
-
Throttle Delay
-
Throttle Hold & Idle Up with
Delay
-
Two independent gyro settings
-
7-point throttle curve
-
Flap Trim
-
"Full Functionality" trainer
system (trainer cord not included)
-
One year limited warranty
Specifications
-
Transmitter;
-
Power Supply: 9.6V NT8S700B
NiCd battery
-
Receiver;
-
Intermediate Frequency:
10.7MHz & 455kHz
-
Power Requirement: 4.8V NiCd
battery
-
Current Drain: 40mA
-
Size: 1.27 x 2.17 x 0.80"
(32.2 x 55.2 x 20.3mm)
-
Weight: 1.25oz (35.5g)
-
Channels: 10
Contents
-
10C Transmitter
-
TP-FSM RF Module
-
R3110 DPS 10 channel Receiver
-
NT8S700B 700mAh Transmitter
Battery, FUTM1460
-
FBC-19B4 TX, RX Wall Charger,
FUTM1830
-
Switch Harness
-
9" Aileron Extension, FUTM3910
-
Neck Strap, FUTM5690
-
Screwdriver
Requirements
Comments
|
|
