Futaba 8FGHS Super 2.4GHz R6208SB
Mode 2 FUTK8011
This is the Futaba 8FGHS Super
2.4GHz 14-Channel Radio System with the R6208SB Receiver and No Servos.
This is the helicopter version
which will default to heli settings when powered up and has a spring loaded
throttle stick.
This version is Mode 2-Left Hand
Throttle and Right Hand Elevator, USA Standard
Features
-
Futaba 8FGHS Super 2.4GHz
R6208SB Mode 2 FUTK8011
-
Ideal for flybarless helis and
all other heli applications
-
New software with menus that
support 3-axis gyros and that are tailored to Futaba's super-fast CGT750
gyro
-
VPP (Variable Pitch Propeller)
compatibility can be set to three conditions for throttle and pitch curve
-
Swash trim can be adjusted
from swash screen
-
Futaba's FASST (Futaba
Advanced Spread Spectrum Technology) shifts very quickly virtually
eliminating signal conficts and interruptions unlike other 2.4GHz systems
that only stay on one or two frequencies
-
Fourteen total transmitter
channels, 12 proportional and 2 switched
-
20-model memory expandable to
unlimited model setups and downloads of online software updates with a 32MG
- 2GB
-
SD memory card (memory card
not included, must be purchased separately)
-
R6208SB receiver accepts a
wide range of batteries, from 4-cell NiCd and NiMH packs to 2S LiFe and LiPo
packs with no regulator required
-
Receiver is capable of
controlling up to eight channels using the outputs for a conventional system
and up to eighteen channels including the two digital channels by using the
output for the S.BUS system, receiver also has a high-speed mode that
delivers ultra fast frame rates on channels 1-6
-
SensorTouch programming
-
Factory defined mixes
-
Stick calibration menus
-
Trainer system (must purchase
Trainer Cord, FUTM4405)
-
One year limited warranty
through Hobby Services beginning at date of purchase
Specifications
-
Transmitter;
-
Transmitting Frequency: 2.4GHz
band
-
Modulation: 2.4GHz 7ch or 2.4G
multi-channel switchable
-
Power Supply: 7.2V HT6F1700B
NiMH Battery
-
R6208SB Receiver;
-
Power Requirement: 3.7 - 7.4V
battery or regulated output from ESC*
-
Size: 0.98 x 1.86 x 0.56"
(24.9 x 47.3 x 14.3mm)
-
Weight: 0.49oz (13.8g) *When
using ESCs make sure that the regulated output capacity meets your usage
application
Contents
-
8FGHS Transmitter
-
R6208SB Receiver, FUTL7668
-
HT6F1700B 1700mAh NiMH
Transmitter Battery, FUTM1480
-
HBC-2B(4) Battery Charger,
FUTM1805
-
Switch Harness
-
Neck Strap
-
Instruction Manual
Requirements
|
|
