Great Planes C-55 Mini Brushed ESC w/BEC GPMM2055

This is the C-55 Mini High Frequency Electronic Speed Control w/BEC. For aircraft requiring high current with 500 or 600 size Brushed Motors requiring 50A or less.

Features

• Great Planes C-55 Mini Brushed ESC w/BEC GPMM2055

• Compact size to minimize weight and simplify installation

• Programmable battery types

• Automatic temperature protection reduces max throttle to 70% when max temperature is reached

• "Safe-Start" system prevents accidental motor starts by disabling the motor circuitry until throttle stick is moved to full throttle, then to the OFF position

• Factory installed radio, motor and battery connectors

• Fully proportional forward with brake

• Battery Eliminator Circuitry provides sufficient power for the receiver and three standard servos. The motor battery powers the receiver and servos. When voltage is reduced to the appropriate value, the Low Voltage cut-off circuitry stops the motor while continuing to supply power to the receiver and servos.

• Solid-state current overload limiter

• Built-in thermal shutdown protection drops throttle to 70% if transistors overheat

• Reverse-polarity protection

• High Frequency to optimize battery run-time and cool operation

• ON/OFF radio switch and set-up LED light

• 180 day limited warranty

Specifications

• Length: 1.42" (36mm)

• Width: .71" (18mm)

• Height: .43" (11mm)

• Weight: 1.22oz (35g) with wires

• Input: 6-12 NiCd/NiMH cells; 2-4 LiPo cells

• Max Rated Current: 50A continuous

• BEC Voltage: 5V/1.5A

• Low Voltage Cutoff: 0.80V per cell for NiCd/NiMH

• 2.75V per cell for LiPo

• Connectors: Universal radio connector, Deans Ultra Male Connector,

• 4mm gold plated Female Bullet Connectors

• Switching Frequency: 1.3kHz

• Motor Size: Speed 500 and 600 Brushed only

Contents

• One C-55 Mini Electronic Speed Control with Universal receiver plug installed, installed motor wires with 4mm gold plated Female

• Bullet Connectors, Deans Ultra Male Battery Connector and an ON/OFF switch

• Three ceramic capacitors to reduce motor noise

• One 2.75" piece of shrink tubing

• One instruction sheet

Requirements

• Attaching to motor and setting up speed control

• Battery pack

• Plug Universal plug into the throttle channel on the receiver

Comments

• Motor wires are White (Positive) and Blue (Ground)

• Do not use with Brushless motors