Great Planes Pro Building Board 16x36x3/4" GPMR6948
This is a Medium size 16x36x3/4" Pro Building Board from Great Planes.
It is a flat, solid surface to build model airplane sections upon.
Features
-
Great Planes Pro Building Board 16x36x3/4" GPMR6948
-
Multiple-section,
finger-jointed wood construction resists warping, so modelers can build with
greater confidence.
-
Fine wood grain surface and
uniform density accepts T-pins easily. Parts are T-pinned in place over the
plans on top of the board, so the airplane structure can be built and then
glued once the parts are in position. This board is designed for
-
planes up to .40 size models.
Specifications
-
Length: 36" (913mm)
-
Width: 16" (406mm)
-
Thickness: 3/4" (19mm)
Contents
Requirements
Comments
-
To prevent warpage, this board
must be allowed to stabilize in moisture content whenever it is moved to the
hot outdoors from an air conditioned indoor area. This can be done by
removing the packaging and standing the board on end for a day or two
allowing air to contact both sides evenly. Warping can occur when placing
one end against a workbench or face down on a table. The slight warping will
go away in time as the entire board reaches the same moisture level. When
one side has more moisture content it will be longer thus causing bowing
usually in the cross grain direction. Once both sides reach the same
moisture level, the board will again be flat.
-
Use the Pin Driver T-Pin Tool
(GPMR8050) to push-in or pull-out the T-pins easily. This tool helps reduce
finger fatigue that T-pins sometimes cause.
|
|
