Hobbico Digital Voltmeter MkIII HCAP0356
This is a Digital Voltmeter MkIII from Hobbico.
Tests 4, 5 & 8 cell R/C batteries in a no-load or a simulated R/C load setting.
Features
-
Hobbico Digital Voltmeter MkIII HCAP0356
-
Custom designed LCD shows
voltage in clear ½" numerals, plus customized characters to easily determine
the meter setting and condition of the battery under test. The LCD not only
displays voltage, but voltage mode, "OK" and "RECHARGE". Test 5 cell packs,
in addition to 4- and 8-cell batteries.
-
Includes a common 9V battery,
located inside an easy-to-access compartment.
-
Built-in simulated R/C load of
250mA for each setting
-
Includes two input controls: a
small pushbutton on the left side of the case, and a 3-position slide switch
on the face of the meter.
-
Switch load OFF and use it as
a true Digital Voltmeter
-
Measures DC voltage up to
19.99V, making it versatile enough for any
-
DC battery -
transmitter/receiver packs, starter batteries, and glow starter batteries.
-
A 10 minute auto-timer shuts
the unit OFF automatically if left ON by accident, to help prevent unwanted
battery drain.
-
Rubber grip for no-slip
handling
-
Color coded banana jacks,
compatible with most common test leads
-
One year limited warranty
Specifications
-
Supply voltage: 9V DC
-
Input test settings under
load: 4.8V DC (4 cell battery)
-
6V DC (5 cell battery)
-
9.6V DC (8 cell battery)
-
Optional load current: 250mA
each setting
-
Maximum voltage measurement:
19.99V DC
-
Length: 4.5" (113mm)
-
Width: 2¾" (67mm)
-
Height: 1" (25.4mm)
-
Weight: 4.7oz (136g)
-
Auto-off timer: Shuts OFF
after 10 minutes
-
Low battery indicator: Battery
symbol in LCD window
Contents
Requirements
-
Test or charge leads with banana plugs such as the Hobbico pre-assembled
test and charge leads (HCAP0101 HCAP0110)
-
HCAP0101 FUTABA J Tx/Rx CHARGE LEADS (NOT FOR 9VAP)
-
HCAP0102 FUTABA J Tx/Rx CHARGE LEADS 9VAP ONLY
-
HCAP0105 JR Tx/Rx CHARGE LEADS
-
HCAP0106 HITEC/AIRTRONICS Z Tx/Rx CHARGE LEADS
-
HCAP0107 CHARGE LEAD GLOW-STARTER - ALL
-
HCAP0108 CHARGE LEAD W/ ALLIGATOR CLIP(2)
-
HCAP0109 VOLTMETER TEST PROBES (2)
-
HCAP0110 CHARGE LEADS 9V Tx PLUG and FUT J Rx
Comments
-
The modeler may purchase the
preceding pre-made Rx and Tx connectors: However, you CANNOT test
diode-protected Tx packs with voltmeters through the radio charge jack. The
pack MUST BE REMOVED from the transmitter to get an accurate voltage
reading.
-
Modelers can make their own
connectors by purchasing one HCAP0310 Banana Plugs, 16 Gauge Wire, and their
radio connector
|
|
