Hot Bodies 67800 1/8 D8T Nitro Truggy Kit

This is the 1/8 scale, glow powered, radio controlled, Hot Bodies off-road D8T Truggy Kit.

Features

• Hot Bodies 67800 D8T Kit

• Chassis: 0.16" (4mm) thick 7075 aluminum with 10° of kickup, composite chassis braces

• Drive: Four wheel shaft drive

• Fuel Tank: 5.1oz (150cc) plastic with flip top cap

• Air Filter: Foam low profile design

• Clutch: 3 shoe, carbon construction

• Clutch Bell: 13 tooth steel

• Transmission: Single speed

• Ball Bearings: Full set

• Shocks: Four oil-filled, 16mm Big Bore aluminum bodied

• Main Gear: 50 tooth steel

• Gearboxes: Sealed

• Differentials: Planetary

• Brakes: Dual fiber discs

• Wheels: White plastic dish wheels, 3.7" (95mm) diameter, 2.3" (58mm) wide, 17mm hex

• Body: Clear untrimmed polycarbonate truggy body

• Bumpers: Front hardened plastic

• Suspension: Captured hinge pin design, extra wide pivot block for optimized geometry

• Caster: Adjustable, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis

• Camber: Adjustable, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle

• Steering: Bell crank type with servo saver

• Warranty Period: Two year limited, valid only in the U.S. Canada, and South America

Specifications

• Vehicle-

• Length: 21" (530mm) from front bumper to end of rear wing

• Width: 15.9" (405mm)

• Weight: 9lbs (4082g) approximately

• Wheelbase: 15-15.1" (380.5-383.5mm) wheels on-center front-to-rear

• Gear Ratio: 4.3:1

• Body-

• Length: 18.2" (462mm)

• Width: 7.4" (188mm) at middle section (widest point) 6.9" (175mm) ahead of front wheels (thinnest point)

• Height: 4.1" (105mm)

Package Contents

• 1/8 scale Hot Bodies off-road Truggy Kit, foam air filter, body, wheels, rear wing, clutch bell, spur gear, instructions and decal sheet

Requirements

• Radio: 2-Channel with 2 Servos (one high torque servo for steering)

• Radio Batteries: (8) AA size

• Receiver Pack: 6V hump

• Engine: .21 cu in (3.4cc) rear exhaust

• Exhaust: Tuned pipe

• Engine Starter: Hand-held type with rubber adapter for vehicle use

• Tires: 1/8 scale off-road truggy

• Glow Starter: 1.2 volt

• Paint: Polycarbonate safe for body

• Misc. Items: Fuel bottle, building and track equipment

• Fuel: 2-cycle glow fuel with 10%-15% nitromethane, 16% lubricant

Comments

• For Replacement Ball Bearings use:

• Qty. Size Location Qty. Bearing Set

• 2 6x10mm Steering 1 DTXC1561

• 6 8x16mm Diffs 3 DTXC1585

• 2 5x11mm Clutch 1 DTXC1547

• 4 8x14mm Front Hubs 2 DTXC1583

• 4 8x14mm Rear Hubs 2 DTXC1583