HPI 15180 Nitro Star T-15L Engine w/PS

This is the HPI Nitro Star T-15L Glow Engine with Pullstarter.

Features

• HPI 15180 Nitro Star T-15L Engine w/PS

• Fits any glow powered car or truck that accepts small block

• (.12-.15) size engines with pull starters

• ABC piston and liner construction "A"luminum piston with a "B"rass cylinder liner that is "C"hrome plated

• 5.5mm rotary carburetor

• HPI R4 medium cold glow plug

• Standard crankshaft

• Side exhaust

• Compatible with the HPI Roto Start 2 Electric Starter System, HPIP7132

• Two year limited warranty through HPI beginning at date of purchase

Specifications

• Displacement: 0.15 cu in (2.49cc)

• Bore and Stroke: 15.0 x 13.6mm

• Maximum Power: 1.2hp/29,000 RPM

• Height from Crankcase Bottom/top of Cylinder Head: 3.9" (98.7mm)

• Distance/Mounting Tab to Exhaust Mounting Hole Center: 1.4" (36.2mm)

• Distance/Starter to Front Bearing: 2.7" (70.1mm)

• Mounting Hole Centers Opposite Side: 1.2" (31mm)

• Mounting Hole Centers Same Side: 0.43" (11mm)

• Width at Mounting Tabs: 1.6" (40mm)

• Front Mounting Hole Center to Front Bearing: 1.2" (29.5mm)

• Center of Carburetor to Center of Crankshaft: 0.97" (24.7mm)

• Cylinder Head Diameter: 1.9" (49mm)

• Crankshaft Size: UNF 1/4-28

• Carburetor Settings:

• **High and low speed needles are factory set and not recommended to**

• **be changed**

• High Speed Needle: Flush with carb body

• Low Speed Needle: Flush with carb body, turn needle in 1/8 turn increments to adjust-no more than two turns from flush

• Idle Adjustment Screw: Set so that clutch does not engage, turn counter clockwise to reduce idle speed, clockwise to increase it

Contents

• HPI Nitro Star T-15L Engine with Pullstarter, Air Filter with Two Elements, R4 Glow Plug, Rotary Carburetor and instruction Manual

Requirements

• Fuel: Car blend glow fuel with 20-25% nitro content

• Glow starter and track equipment