HPI 74108 Pro Glow Plug Ignitor w/AC Charger

This is a Glow Plug Igniter with Cap Meter and AC Charger from HPI Racing. The glow starter is used to heat a glow plug while starting an engine.

Features

• HPI 74108 Pro Glow Plug Igniter w/AC Charger

• Hot pink machined and knurled aluminum battery holder.

• NiCd cell provides higher voltage under a load than an alkaline cell.

• Meter has green area for charged and red area for must recharge.

• Spring-loaded locking socket design.

• Comes on a picture instruction header card.

Specifications

• Adaptor Input: AC 120V~60Hz 2W (United States Standard)

• Adaptor Output: DC 1.25V at 170mA

• Shaft Length: 2-1/4" (57mm)

Contents

• One Glow Starter with Cap Volt Meter.

• One Panasonic 1.2volt, 1300mAh sub-C size NiCd Battery

• One AC Charger (United States Standard)

Requirements

• Charging of NiCd battery for ten hours before use.

Comments

• Battery for this glow-starter can be replaced with another sub-C type battery by unscrewing the battery holder.