HPI Nitro Star F4.6 w/Pullstart 1495
This is HPI's Nitro Star F4.6 .28 size Engine With Pullstarter.
Can be installed in the HPI Savage X 4.6 Monster Truck, HPID67**
for those who prefer an engine with a pull starter.
Features
-
HPI Nitro Star F4.6 w/Pullstart 1495
-
Composite construction slide
valve, 7.5mm 3 needle carburetor, high speed needle, idle screw and low
speed needle are set flush with the carburetor body for factory settings 8
port chrome plated brass sleeve
-
ABC cylinder construction, "A"luminum
piston with a "B"rass cylinder that is "C"hrome plated
-
Purple anodized billet
aluminum heat sink head
-
Round rear exhaust port
-
Cast aluminum crankcase with
heatsink fins
-
Machined pilot shaft
crankshaft with collet preinstalled
-
Knife-edge billet aluminum
connecting rod with dual bushings.
-
High flow 2-stage air filter
dramatically reduces intake restriction as it smoothes and straightens air
flow
-
Two year limited warranty
Specifications
-
Height/bottom of Mounting
Flanges/top of Cylinder Head: 4" (101mm)
-
Height/bottom of Crankcase/top
of Cylinder Head: 4.5" (114mm)
-
Length from Pull Starter to
Front Bearing: 3.3" (84.5mm)
-
Length from Pull Starter to
end of Crankshaft: 4.6" (117mm)
-
Width at Mounting Flanges:
1.81" (45.9mm)
-
Mounting Hole Center Same
Side: .82" (21mm)
-
Mounting Hole Center Opposite
Side: 1.42" (36mm)
-
Bore: 18.68mm
-
Stroke: 16.6mm
-
Horsepower: 2.9 @ 32,000 RPM
-
Crankshaft diameter: 5mm
(clutch bell area)
-
Crankshaft diameter: 6.7mm
(threaded portion)
-
Displacement: 4.6cc (.28 ci)
Contents
-
Nitro Star .28 F4.6 glow
engine
-
Glow Plug - HPI R5 cold plug
(HPIG1504 for a replacement)
-
Dual Stage Air Filter
(HPIC7198 for replacement)
-
Instructions and exploded
views
Requirements
|
|
