HPI Nitro Star K4.6 Engine w/Pull Start 15201
This is HPI's Nitro Star K4.6 .28 size Engine With Pullstart.
This is the standard engine for the Savage SS .28 monster truck kit.
Features
-
HPI Nitro Star K4.6 Engine w/Pull Start 15201
-
Composite construction slide
valve, 3 needle carb with hand adjustable high speed needle (the stock carb
settings are made flush for convenient "back to factory settings")
-
8 port chrome plated brass
sleeve
-
True ABC cylinder construction
-
Purple anodized machined
aluminum heat sink head
-
Rear exhaust round port
-
Cast aluminum crankcase
features heatsink fins
-
Machined pilot shaft
crankshaft with collet preinstalled
-
Knife-edge billet aluminum
connecting rod with dual bushings.
-
Dual stage air filter
dramatically reduces intake restriction as it smoothes and straightens air
flow
Specifications
-
Crankcase: 3.29" (83.5mm)
(from rear of case to front without shaft)
-
Height: 4.40" (111mm) (from
bottom of case to the top of the head)
-
Width: 1.81" (mount flange)
-
Mount Holes: 1.42" (measured
from center to center width)
-
Mount holes: .82" (Between
holes front and back)
-
RPM: Max 39,000 RPM
-
Horsepower: 2.9 @ 35,000 RPM
-
Crankshaft diameter: 5mm
(clutch bell area)
-
Crankshaft diameter: 6.7mm
(threaded portion)
-
Crankshaft screw: 3 x 12mm
caphead screw
-
Capacity: 4.60cc (.28 ci)
Contents
-
Nitro Star .28 (4.6) glow
engine
-
Glow Plug - HPI R5 cold plug
(HPIG1504 for a replacement)
-
Dual Stage Air Filter
(HPIC7198 for replacement)
-
Instructions and parts break
down
Requirements
|
|
