Multiplex Easy Glider Pro Kit Built/Glider or Electric M214226
This is the radio controlled, glider or electric powered
Multiplex Easy Glider Pro almost ready to fly Sailplane. The EasyGlider PRO is an updated model based on the popular and proven EasyGlider and EasyGlider electric. Just like the larger Cularis the Easy Glider PRO can be built as a pure glider or as an electric by adding the optional power pack. The Easy Glider Pro’s flying characteristics are perfect for the beginner, although this by no means implies that the more advanced pilot won’t enjoy it - quite the contrary. If you are an expert you will soon discover that the EasyGlider PRO has the kind of performance only seen with much larger and more expensive gliders. • Low sink rate• Can be ballasted to expand the airspeed range• Landing aid - both ailerons raised• Pre-fabricated molded ELAPOR® parts• Convenient method of aileron servo connection when the wings are fitted• Two-part wing with removable spar joiner for easy transportation
Features
-
Multiplex Easy Glider Pro Kit Built/Glider or Electric M214226
-
Construction: Elapor foam to
resist damage, white in color
-
Wings: Two piece with
fiberglass wing joiner
-
Spinner: Elapor foam 2.2"
(55mm) diameter
-
Aileron Control: Dual servo
-
Control Surfaces: Elevator,
rudder and ailerons
Specifications
-
Wingspan: 71" (180.3cm)
-
Length: 43.7" (112.3cm)
-
Flying Weight: 28.5oz (810g)
with standard power system
-
Wing Loading: 6.5 oz sq ft (20
g sq/dm) with standard power system
-
Wing Area: FAI approx. 226 sq
in (41.6g/sq dm)
-
Airfoil: Semi symmetrical
-
CG (Center of Gravity): 2.7"
(70mm) from leading edge at wing root measured at fuselage side
-
Control Throws-
-
Elevator, Up and Down:
0.31-0.39" (8-10mm)
-
Rudder, Left and Right:
0.59-0.79" (15-20mm)
-
Ailerons, Up: 0.59" (15mm)
-
Down: 0.24" (6mm)
-
Spoilers-Both Ailerons Up:
0.79" (20mm)
-
Spoiler Mixer (Elevator Trim
Compensation): 0.16" (4mm)
Contents
-
One Multiplex Easy Glider Pro with decal sheet, foam spinner, wing
joiner, pushrods, hardware and illustrated instruction manual
Requirements
-
Radio System: 4-channel with
micro receiver
-
Servos: Two micro size for
elevator & rudder Two nano size for ailerons
-
Servo Extensions: Two 16"
(200mm) for aileron servos
-
Y Harness: For aileron servos
-
Battery: at least 2100mAh
-
Battery Charger: LiPo
compatible
-
If building as glider only the
following items are required; NiMH Receiver Battery (at least 1800mAh)
Switch Harness with Charge Jack Launching Kit
-
If installing electric power
the following items are required;
-
Easy Gilder Pro Power Set #33
2636 or upgraded Power Set #33 2642
-
Propeller Driver and Spinner
#73 3500 (MPUG3226)
-
Building and Field Equipment:
Medium viscosity regular (NOT syrofoam safe) CA glue and activator, see
COMMENTS
Comments
|
|
