Novak 3160 Kinetic Spec/Ballistic BL System 10.5T/4200Kv

This is the Ballistic Spec Brushless 10.5 Turn Motor and the Kinetic Spec Electronic Speed Control from Novak.

Features

• Novak 3160 Kinetic Spec/Ballistic BL System 10.5T/4200Kv

• Motor-

• Completely rebuildable allowing upgrades or replacement of various parts

• Easy to adjust timing assembly

• Meets ROAR and IFMAR specifications

• Oversized front bearing 1/2 x 3/16" (12.7 x 4.8mm) for increased load handling and bearing life

• 12.3mm nickel-plated sintered neodymium rotor for maximum

• performance in high-temperature conditions

• 0.125" (3.2mm) pinion shaft accepts all existing pinion gears

• Sensor-based for excellent torque and low-speed driveability

• Compatible with the Novak GTB, Slyder and Havoc 3S electronic speed controls

• Color-coded hand wound stator identifies number of motor winds

• Heavy duty solder tabs

• ESC-

• Meets specifications for ROAR Sportsman Class Racing

• Multiple adjustable parameters via on-board or optional PC interface;

•   Minimum Brake, Drag Brake, Minimum Drive, Timing Level, Timing Set

•   Point, Dead Band, Throttle Curve, Brake Curve, Brake Frequency,

•   Brake End Point, Drive Frequency, Motor Rotation and Voltage

•   Cut-Off

• Compatible with the NovaLink (version 1.4.3 or higher) for advanced programming options

• NovaBrakes for instant braking under any timing condition, adjustable brake frequency and endpoint

• On-board Hall Sensor Test to verify proper sensor operation

• Maximum available electronic motor timing-more than 50° plus boost with eight on-board settings

• Battery selection circuitry for LiPo LiFe and NiMH batteries

• Locked rotor detection and thermal overload protection with on-board temperature diagnostics

• 120 day limited warranty on both components through manufacturer

Specifications

•   Motor-

• Watts: 235

• kV: 4,200 RPM/volt (unloaded)

• Color-Coded Stator: Blue

• Maximum RPM: 50,000

• Sensor Harness Length: 9" (230mm)

• Motor Size: 2.07 x 1.41" (52.6 x 35.8mm) (540 size)

• Motor Weight: 6.6oz (187g)

• Shaft Diameter: 0.125" (3.2mm)

•   ESC-

• Weight Without Wires: 1.15oz (32.60g)

• Input Voltage: 1-2S LiPo/LiFe cells or 4-6 NiMH cells (1.2V/cell)

• Size: 1.16 x 1.47 x 0.70" (29.5 x 37.3 x 17.8mm)

• Motor Limit: 540 (8.5T Limit) and 550 (5.5T Limit) sensored brushless

• On-Resistance: 0.00040 ohms @ 25°C trans. temp

• BEC: 6.0 volts DC/2.0 amps

• Status LEDs: 5

• Voltage Cut-Offs: 6.25V (Li-Po), 4.75V (Li-Fe) adjustable via NovaLink

• Power Wires: 14G Super-Flex Copper-Strand Silicone

Contents

• Ballistic Spec Brushless 10.5 Turn Motor with Sensor Wire and Kinetic Spec ESC, Heat Sink, Power Trans Cap Module. Double-Sided Tape and Instruction Sheet

Requirements

• Installing in vehicle and connecting to battery and receiver