O.S 18642 91HZ-R 3D Speed Blk 61G
This is the O.S. Engines 91 HZ-R
3D Speed Helicopter Engine in Black.
****** Because of the competition
nature of this engine,******
******it is NOT covered by the O.S.
2 Year Warranty.******
Features
-
O.S 18642 91HZ-R 3D Speed Blk
61G
-
Designed for all-out 3D
competition
-
Demand Regulator System
ensures consistent fuel delivery from full to empty
-
165° exhaust timing for
optimal horsepower and stable hovering
-
Newly designed combustion
chamber shaped to match the big bore carburetor and advanced exhaust
cylinder timing
-
Big Bore carburetor is
designed to develope stable horsepower at 70-80% throttle which is widely
used in 3D flight
-
Crankshaft counter-weight
reduces vibration at high RPM
Specifications
-
Displacement: 0.91cu in
(14.9cc)
-
Bore: 1.091" (27.7mm)
-
Stroke: 0.976" (24.8mm)
-
Output: 3.6hp/15,500 RPM
-
Practical RPM Range: 2,000 -
16,000 RPM
-
Weight (w/o Muffler): 21.27oz
(603g)
-
Crankshaft Size: 5/16-24
-
Height from crankcase bottom
to top of cylinder head: 4" (103mm)
-
Height/bottom of mounting tab
to top of cylinder head: 3.1" (79mm)
-
Distance between mounting hole
centers same side: 0.98" (25mm)
-
Distance/mounting hole centers
opposite side: 2" (52mm)
-
Distance/center of muffler
screw holes: 1.6" (42mm)
-
Distance/bottom of mounting
tab to muffler screw holes: 1.7" (42.8mm)
-
Distance/crankshaft center to
throttle control arm: 1.6" (42mm)
-
Length from front bearing to
backplate: 3.3" (84mm)
-
Length from backplate to end
of crankshaft: 4.5" (116mm)
-
Width of crankcase below
mounting tabs: 1.7" (43mm)
-
Width between mounting tabs:
2.4" (61mm)
-
Carburetor Adjustments-
-
High Speed Needle Valve: Turn
approximately 30° (3-4 clicks) during initial adjustments, then
approximately 15° (1-2 clicks) when making final adjustments
-
Medium Speed Needle Valve:
Turn approximately 30° (3-4 clicks) at a time
Contents
-
91 HZ-R 3C Speed Helicopter
Engine with #8 Glow Plug, Aluminum Check Valve, 0.008" (0.2mm) Head Gasket,,
Aluminum Control Arm, two Needle Adjusting screws and Instruction Manual
Requirements
-
Fuel: 10%-30% nitromethane
with at least 18% lubricant. Lubricants may be either castor or synthetic
oil or castor/synthetic blend.
-
Field Equipment: glow starter,
fuel bulb, fuel can filter, fuel pump hexagonal starting shaft (depending on
brand of helicopter) electric starter, battery and fuel tubing
-
Muffler-Depending on heli
|
|
