-
Displacement: 1.548 cu in
(25.36cc)
-
Bore: 1.323" (33.6mm)
-
Stroke: 1.126" (28.6mm)
-
Practical RPM: 2,000 - 10,000
RPM
-
Power Output: 2.6hp @ 10,000
RPM
-
Engine Weight: 28.40 oz (805g)
-
Muffler Weight: 3.35oz (95g)
-
Carburetor Settings-
-
Needle Valve: 2-1/2 - 3 turns
from fully closed
-
Mixture Control Valve: Factory
set, make only small adjustments if needed, after adjusting needle valve as
described in manual, turn 30° to lean idle mixture or 90° counterclockwise
to richen mixture then back again 45° clockwise
-
Width at Mounting Tabs: 2.6"
67mm)
-
Crankcase Width below Mounting
Tabs: 1.8" (47mm)
-
Length from Drive Washer to
rear of Carburetor: 5" (127.5mm)
-
Height from Mounting Tab to
Pushrod Cover: 4.5" (114mm)
-
Height from bottom of
Crankcase to Pushrod Cover: 5.4" (138.6mm)
-
Distance between Mounting Hole
Centers Same Side: 0.98" (25mm)
-
Distance between Mounting Hole
Centers Opposite Side: 2.3" (58mm)
-
Distance/front Mounting Hole
Center to Drive Washer: 2.5" (64.5mm)
-
Distance/ Center of Engine to
Drive Washer: 3.03" (77mm)
-
Crankshaft Size: 5/16-24